BOYSEN®® Epoxy Enamel

BOYSEN®® Epoxy Enamel is a high quality, two-component, epoxy-polyamide system that has excellent chemical resistance.

B‑2101 and B‑2103 serve as Curing Agents designed to be compounded with Epoxy Enamel White and Epoxy Enamel Colored, respectively.

SURFACE PREPARATION

Allow new concrete to dry for 14-28 days under normal weather conditions before painting.

Painting over a roughened concrete floor is recommended to improve adhesion of succeeding coats.

Remove oil and grease by using detergents or degreasers.

Surface to be painted should be clean and dry, free from dust, dirt, contaminants, and all loose grit and mortar.

PAINTING SCHEDULE

Mix 3 parts of BOYSEN®® Epoxy Primer White B‑2200 to 1 part of its catalyst. Allow 20 minutes induction time.

Thin the prepared mixture with BOYSEN®® Epoxy Reducer B‑55 in a 1:1 ratio.

Apply as primer coating on bare concrete floors. Let dry overnight.

Mix 3 parts BOYSEN®® Epoxy Enamel and 1 part of its catalyst. Allow 20 minutes induction time.

Apply 2 to 3 coats of prepared BOYSEN®® Epoxy Enamel. Allow 8 hours to overnight before recoating.

NOTES

Use only BOYSEN®® Epoxy Reducer as thinning solvent.

Application of topcoat should be done within 7 days after priming to ensure good intercoat adhesion, otherwise re-application of primer is needed.

Allow the product to cure for 3 days for foot traffic abrasion and 7 days for heavy-duty use.

Colors

B‑2100

White

B‑2130

Silver Gray

B‑2132

Gray

B‑2140

Royal Blue

B‑2151

Dark Green

B‑2171

International Red

B‑2190

Black

* For technical reasons connected with color reproduction in print and paint manufacturing, these colors may not exactly match actual paint color.

Paintable Surface Area

SQM

Paint System	Product	Quantity
Primer	BOYSEN®® Epoxy Primer White B‑2200	3	L
Topcoat	BOYSEN®® Epoxy Enamel	14	L
Thinning Solvent for Primer	BOYSEN®® Epoxy Reducer B‑55	3	L
Thinning Solvent for Topcoat	BOYSEN®® Epoxy Reducer B‑55	4	L

* Quantity shown will only be an estimate

1 Gallon = 4 Liters

Want to try again with a different set of selections?

Start over with the button below

Start Over

For MSDS requests, please email technical@boysen.com.ph